What makes polyurethane resin demanding to pump
- High viscosity, which rises further in the cold: the pump is sized on the viscosity at the lowest working temperature.
- Reacts with moisture: seal and lines must keep humid air out.
- Part of a two-component system: the steadiness of the flow affects the mixing ratio.
Send us the data of your polyurethane resin: we reply within 24 hours with the right pump.
Recommended configuration
Series ZV for small flows and machine-side lines; Series NAV for transfer and larger flows.
| Recommended series | Series ZV, Series NAV |
|---|---|
| Flow range of these series | 0.47 – 2,770 l/min (450–1,450 rpm) |
| Pump body | Cast iron; stainless steel where required |
| Heating | Not needed in normal conditions; to be considered if viscosity rises too much in the cold |
| Rotation speed | Low, towards 450 rpm |
| Shaft seal | Protected from moisture |
| ATEX | On request |
| Connections | ZV: threaded, flanged to the motor NAV: UNI flanges DN 40–DN 125 PN 16 |
| Direction of rotation | Reversible |
Indicative configuration: we confirm it on your viscosity, temperature, flow and pressure data.
Send us the data of your polyurethane resin: we reply within 24 hours with the right pump.
Where it is used
This page also covers: Poliuretano.
Data we need for the quote
- Fluid and, if available, its technical or safety data sheet
- Required flow rate (l/min or m³/h)
- Viscosity at the lowest working temperature
- Discharge pressure and suction conditions
- Mains voltage and frequency (50/60 Hz)
Only the fluid, flow and your email are required: we can complete the rest together.
Send us the data of your polyurethane resin: we reply within 24 hours with the right pump.
Frequently asked questions
Which pump do you recommend for polyurethane resin?
An external gear pump: Series ZV for small flows and machine-side lines; Series NAV for transfer and larger flows. The final configuration depends on viscosity, temperature, flow and pressure.
How do you avoid problems with moisture?
With a seal that keeps humid air out, closed lines and, where needed, a dry gas blanket on tanks. The pump should not stand idle open to the air.
Can the pump deliver an exact quantity?
The inverter lets the pump reach the desired instantaneous flow by varying its speed. Delivering a precise quantity and stopping at the right moment is done by the plant control system.
Is the pump reversible?
Yes, NAV, ZV and CR pumps can run in both directions: useful for emptying lines back into the tank.
How quickly do you reply?
Within 24 hours, with the recommended pump, configuration and price. You can also write to us on WhatsApp.